Mitutoyo EJ-102N - Parameter Setting; Setting Procedure

30
No. 99MBC139A
3 Operation Procedure
3.3 Parameter Setting
You can set parameters to specify criteria such as the counter direction, display, and external output.
Congurethesettingsasappropriatetoyourrequirements.
Tips
• For details about basic parameters, see "■Basicparameters"onpage32.
• For details about advanced parameters, see
"■Advancedparameters"onpage34.
3.3.1 Setting Procedure
Parameter settings can be made either by operating the keys on the counter, or externally through the
optional interface unit.
■Setting parameters by key operation
1
Press and hold the [Fn] key, and then press the [MODE] (>) key.
» Display enters the parameter setting screen.
MODE
Fn
SEL / CE
Ch.
TIR
P.SET
Parameter Number Set value
2
Display the Parameter Number of the parameter to be set.
The Parameter Number changes each time you
press the [SEL/CE] key.
MODE
Fn
SEL / CE
Ch.
TIR
P.SET
Parameter Number
Axis being set
(parameters that can be set for individu-
al axes only)
Set value
Tips
• With some parameters, values are set separately for the A-axis and B-axis. For parameters that are set
separatelyfortheA-axisandB-axis,thesettingscreenfortheA-axisisdisplayedrst,andthenthesetting
screen for the B-axis appears upon pressing the [SEL/CE] key.
• You can cycle through the Parameter Numbers in reverse order by pressing the [SEL/CE] key together with
the [Fn] key.