Mitutoyo EJ-102N - Attaching the DIN Rail Fixing Bracket

11
No. 99MBC139A
2 Setup
2.1.3 Attaching the DIN Rail Fixing Bracket
EJCountersattachedtotheDINrailcanbefastenedinplaceusingtheoptionalDINrailxingbracket
(Part No. 21HZA157).
1
HooktheclipthatisclosertothescrewholeinthexingbracketontotheDINrail,thenpress
toward the opposite side and hook the other clip onto the rail.
Screw hole
DINrailxingbracket
1
2
2
SlidethexingbracketalongtheDINrailtowhereitcomesincontactwiththeEJCounter.
DINrailxingbracket
3
Fastenthexingbracketinplacebythreadingthescrewprovidedwiththexingbracketinto
the screw hole in the bracket, and then tightening the screw so that it presses against the DIN
rail,immobilizingthexingbracket.
Tips
The screw provided with the bracket is suitable for fastening to a TH35-7.5 rail.
Adi󰀨erentscrew(M4)mustbeusedforfasteningtoaTH35-15rail.
4
Repeat steps 1 through 3 toattachaxingbrackettotheoppositesideoftheEJCounter.