Mitutoyo EJ-102N - Setup; Mounting; DIN Rail Attachment; Removal

9
No. 99MBC139A
2 Setup
2
2 Setup
2.1 Mounting
2.1.1 DIN Rail Attachment / Removal
The EJ Counter is attached to a DIN rail for use.
AfterrstremovingLinearGagesandconnectorplugs,theEJCounterisattachedtoorremovedfrom
the DIN rail a unit at a time.
Tips
A DIN rail must be provided by the customer.
Suitable DIN rail type names (IEC 60715): TH35-7.5Al, TH35-7.5Fe, TH35-15Fe
■Attachment
Press the clip (gray) on the rear side of the EJ Counter onto the DIN rail, and then hook the clip on the
opposite side onto the DIN rail.
1
2
DIN rail
■Removal
Pressing the EJ Counter in the direction indicated by arrow 1, raise the clip on the opposite side so that
it comes clear of the rail.
1
2