Mitutoyo EJ-102N - Effect of Changing the Display Mode

39
No. 99MBC139A
3 Operation Procedure
3.3.4 E󰀨ectofChangingtheDisplayMode
When display mode selection is changed with Parameter Number 03 and displayed content is the same
before and after changing the setting, the tolerance value, preset value and preset state settings are
maintained.
Ifthedisplayedcontentdi󰀨ersafterthesettingischanged,thetolerance,presetvalue,andpresetstate
settings are re-initialized.
Tips
Settingsarealsomaintainedifthesamecontentisdisplayedbetweendi󰀨erentchannelsbeforeandafterset-
ting changes. For example, if the display mode is changed from 1 to 3, the setting of display mode 1 for Ch. 1 is
passed to display mode 3 for Ch. 2.
Display mode after change
0 1 2 3 4 5 6 7
Ch. 1 Ch. 2 Ch. 1 Ch. 2 Ch. 1 Ch. 2 Ch. 1 Ch. 2 Ch. 1 Ch. 2 Ch. 1 Ch. 2 Ch. 1 Ch. 2 Ch. 1 Ch. 2
A-axis coordinates B-axis coordinates Sum (A+B) B-axis coordinates Di󰀨erence(A-B) B-axis coordinates A-axis coordinates Sum (A+B) A-axis coordinates Di󰀨erence(A-B) A-axis speed B-axis speed A-axis coordinates A-axis speed B-axis coordinates B-axis speed
Display mode before change
0
Ch. 1
A-axis coordinates
  
Ch. 2
B-axis coordinates
  
1
Ch. 1 Sum (A+B)

Ch. 2
B-axis coordinates
  
2
Ch. 1 Di󰀨erence(A-B)

Ch. 2
B-axis coordinates
  
3
Ch. 1
A-axis coordinates
  
Ch. 2 Sum (A+B)

4
Ch. 1
A-axis coordinates
  
Ch. 2 Di󰀨erence(A-B)

5
Ch. 1 A-axis speed

Ch. 2 B-axis speed

6
Ch. 1
A-axis coordinates
  
Ch. 2 A-axis speed

7
Ch. 1
B-axis coordinates
  
Ch. 2 B-axis speed
