Mitutoyo EJ-102N - Connecting the AC Adapter (Optional)

18
No. 99MBC139A
2 Setup
2.3.3 Connecting the AC Adapter (Optional)
This section describes the procedure for DC power supply connection using the following options.
y DC jack with pin terminals (Part No. 21HZA209)
y AC adapter (Part No. 357651)
y AC cable (Part Number varies according to destination country or region.)
For details, see
"6.3 Options" on page 58
1
Connect the DC jack with pin terminals to the provided connector plug.
Push the pin terminal attached to the DC jack's red cable all the way in to terminal A, and the pin termi-
nal connected to the black cable all the way into terminal B.
Tips
With the DC jack that is equipped with pin terminals, press the terminals directly into the holes.
A (Connect the terminal of the red cable.)
B (Connect the terminal of the black cable.)
●
Disconnecting the cable
Todisconnectthecablefromtheplug,pulloutwhilepressingthebuttonswithaat-headprecision
screwdriver or the like.
NOTICE
Forcibly pulling the connector plug out will result in damage to the connector or discontinuities in the cable.
2
Center the levers on both sides of the connector plug.
Tips
The levers have three discrete positions. If the levers are in the bottom-most position (A), it will be hard to plug
the connector plug into the EJ Counter.
A