Mitutoyo EJ-102N - Page 33

19
No. 99MBC139A
2 Setup
3
Plug the connector plug into the I/O connector on the EJ Counter.
Align the claws on the levers on the side of the connector plug with the holes on both sides of the I/O
connector, and then plug the connector plug into the I/O connector on the EJ Counter.
Push the connector plug in to where its claws engage with the holes on both sides of the I/O connector
and the lever won't go any further.
NOTICE
When you need to unplug the connector plug, do so by operating the levers on both sides so that the claws
disengage from the EJ Counter connector and then pulling the plug out of the connector on the EJ Counter (to
theleftasindicatedinthegurebelow).Forciblypullingtheconnectorplugoutwillresultindamage.
4
Connect the power cable to the AC adapter, and then plug the power plug into the outlet.
5
Connect the AC adapter to the DC jack with pin terminals.
Tips
Make sure that the AC adapter does not come loose from the DC jack with pin terminals during measurement.