Mitutoyo EJ-102N - Page 38

24
No. 99MBC139A
3 Operation Procedure
■Returning to the count value that preceded preset
Tips
Return to the count value that preceded preset is only possible for the currently value display. When the max-
imum,minimumandrun-out(di󰀨erencebetweenmaximumandminimum)valuesaredisplayed,rstreturn
display to the current value display.
For details, see
"3.2.3 Peak Hold" on page 25.
1
Display the channel for which you wish to restore the count value that preceded preset.
Tips
For details, see "3.2.1 Switching the Display Channel (Ch.)" on page 22.
2
Press and hold the [Fn] key, and then press the [P.SET] (^) key.
» The preset is canceled and the preceding
count value is restored.
» This clears the maximum and minimum values
and the run-out width.
MODE
Fn
SEL / CE
Ch.
TIR
P.SET
1