Mitutoyo EJ-102N - Page 56

42
No. 99MBC139A
4 Data Output
2
Center the levers on both sides of the connector plug.
Tips
The levers have three discrete positions. If the levers are in the bottom-most position, it will be hard to plug the
connector plug into the EJ Counter.
A
3
Plug the connector plug into the I/O connector on the EJ Counter.
Align the claws on the levers on the side of the connector plug with the holes on both sides of the I/O
connector, and then plug the connector plug into the I/O connector on the EJ Counter.
Push the connector plug in to where its claws engage with the holes on both sides of the I/O connector
and the lever won't go any further.
NOTICE
When you need to unplug the connector plug, you can do so by manipulating the levers on both sides so that
the claws disengage from the EJ Counter connector and pulling it out of the connector on the EJ Counter (to
theleftasshowninthegurebelow).Forciblypullingtheconnectorplugoutwillresultindamage.