No. 99MAH040B
・ Do not use a sharp-pointed tool to remove the battery holder and not pry out the
battery holder, to prevent damage to the battery holder.
・ Note not to damage your nail when the battery holder is removed by hand.
・ If the battery and battery holder is not set properly, a damage andmalfunction may
result.
・ If the Measurement mode is not entered after executing the above procedure, set the
battery again.
・ If the instrument will not be used for more than three months, remove the battery and
store it separately to prevent damage by battery leakage.
・ The supplied battery is used only to check the functions and performance of the
instrument, so it may not meet the battery life specification.
2.2 Adjusting Display Angle
The display can be rotated 90° (to position A) clockwise or 240° (to position B)
counterclockwise from the initial position. (For the rotating range, see 1. Part Names and
Dimensions.)
・ Stoppers are set at both positions A and B. Stop rotating the display at the stoppers, or
the instrument may malfunction.
・ Do not push in the display or pull it out. Doing so may cause the instrument to
malfunction.
2.3 Mounting on the bore gage
This instrument is used by mounting on a bore gage (optional) correctly. For details, refer
to the User‘s Manual of the bore gage.
To Next Page
Loading...
