Mitutoyo ID-C112GXB - 5 Error Messages and Actions

No. 99MAH040B
5-1
5 ERROR MESSAGE AND
ACTION
This chapter describes the error messages and their corrective
actions.
If any error occurs in this Digimatic indicator, a corresponding error message is displayed.
If the instrument does not recover the normal conditions after corrective actions, contact
your dealer or Mitutoyo sales office.
Display
definition
Actions
Low battery alarm
・ Battery voltage is getting
low
・ Replace the battery with the
new one.
Low battery error
・ Measurement cannot be
performed due to
consumption of the
battery.
・ Replace the battery with the
new one.
Sensor signal synthesizing
error
・ Synthesizing of sensor
signal is failed.
・ A sensor signal
synthesizing error occurred
while the spindle was
moving at high speed.
Keep on using the indicator
since this error does not
affect measured values.
* If this error occurs while the
spindle is stopped, it could
be due to sensor failure. In
this case, contact the
nearest Mitutoyo sales
office.
5