No. 99MAH040B
3.3 Setup Mode
The following parameters can be checked or set in the setup mode.
Starting up the setup mode
Press the upper right key in the measurement mode to move into the setup mode.
Selecting parameters
1. The blinking cursor indicates the currently selected parameter.
2. Press the lower left or lower right key to display the current set parameter.
・Pressing the lower left key, the cursor moves in the following order: TOL→RES
→ ... →OTHER→TOL.
・Pressing the lower right key, the cursor moves in the following order: TOL→
OTHER→ ... →RES→TOL.
3. Press the center key to move the parameter setting
Completing the setup mode
Press the upper right key to complete setup mode and return to the measurement
mode,
・ During the setup mode, key assists which correspond to each key will be displayed.
(Refer to "1.4 Details of Display Unit".)
・ The setup parameters will be registered even after the battery is replaced or power is
turned off. However, if the battery is replaced while the key-lock function is enabled, the
key-lock function will be set off.
・ The power supply cannot be turned off with the upper left key in the setup mode.
To Next Page
Loading...
