Mitutoyo ID-C112GXB - 3.3.5.2 Analog Bar Display (RULER)

No. 99MAH040B
3-28
3.3.5.2 RULER(2): Analog bar display
Analog bar can be set up displayed or hidden.
 Hiding the analog bar
1. Press the upper right key in the measurement mode to move the setup mode, and
select OTHER functions. (Refer to "3.3.5 OTHER: Other functions".)
2. Press the lower left or lower right key until "RULER" is blinking.
3. Press the center key to move the ON/OFF selection of the analog bar display.
4. Press the lower left key to select "OFF".
5. Press the center key to hide the analog bar and return to the parameter setting.
(Refer to "3.3 Setup Mode".)
 Displaying the analog bar
1. Press the upper right key in the measurement mode to move the setup mode, and
select OTHER functions. (Refer to "3.3.5 OTHER: Other functions".)
2. Press the lower left or lower right key until "RULER" is blinking.
3. Press the center key to move the ON/OFF selection of the analog bar display.
4. Press the lower left key to select "ON".
5. Press the center key to hide the analog bar and return to the parameter setting.
(Refer to "3.3 Setup Mode".)
NOTE
・ The analog bar will not be displayed if the graduation is changed while it is hidden.
(Refer to "3.3.3 SCALE: Selecting analog bar graduation".)