Mitutoyo ID-C112GXB - 3.3.5.3 FAST Mode

No. 99MAH040B
3-30
3.3.5.3 FAST(3): FAST mode
When enabling the FAST mode, the minimum value detection mode, it enables to detect
minimum value more correctly.
Auto-off function is disabled in FAST mode.
 Enabling the FAST mode
1. Press the upper right key in the measurement mode to move the setup mode, and
select OTHER functions. (Refer to "3.3.5 OTHER: Other functions".)
2. Press the lower left or lower right key until "FAST" is blinking.
3. Press the center key to move the ON/OFF selection of the FAST mode.
4. Press the lower left key to select "ON".
5. Press the center key to enable this function and return to the parameter setting.
(Refer to "3.3 Setup Mode".)
 Disabling the FAST mode
1. Press the upper right key in the measurement mode to move the setup mode, and
select OTHER functions. (Refer to "3.3.5 OTHER: Other functions".)
2. Press the lower left or lower right key until "FAST" is blinking.
3. Press the center key to move the ON/OFF selection of the FAST mode.
4. Press the lower left key to select "ON".
5. Press the center key to disable this function and return to the parameter setting.
(Refer to "3.3 Setup Mode".)
IMPORTANT
・ The accuracy will not be affected by this function.
NOTE
・ Operating in this function will shorten the battery life.
It is recommended to operate with disabling this function if not necessary.