No. 99MAH040B
3.3.3 SCALE: Analog bar graduation
The analog bar graduation (Display range: ±20) can be changed.
Selecting a graduation of analog bar
1. Press the upper right key in the measurement mode to move the setup mode.
2. Press the lower left or lower right key to move the blinking cursor to "SCALE".
3. Press the center key to set the analog bar graduation.
4. Press the lower left or lower right key to switch the analog bar graduation.
5. Press the center key to set the analog bar graduation and return to the parameter
setting. (Refer to "3.3 Setup Mode".)
・ Press the upper left key to cancel the operation.
・ The factory default of the analog bar graduation is "Auto". Change it as required.
・ If the analog bar graduation is set to "0.0005mm" or "0.0002mm", the resolution will be
"0.001mm". Because the resolution of the spindle displacement "x" is "0.001mm".
・ The analog bar will be displayed based on the display value. If the analog bar
graduation is selected lower than the resolution of display value, the analog bar will
vary discontinuously.
・ When the unit is switched, the graduation of the analog bar will be automatically
changed accordingly. After switching the unit, check the graduation of the analog bar.
・ The graduation of the analog bar will change automatically in the following conditions:
1. Tolerance judgment ON: Graduation will change tolerance values to be within the
display range.
2. Changing resolution: Graduation will change same as resolution.
To Next Page
Loading...
