No. 99MAH040B
4 DATA OUTPUT
This chapter describes how to output data.
The measurement data can be outputted to the data processor such as Digimatic
Mini-processor DP-1VR with an optional connecting cable (Parts No. 905338 (1m) or No.
905409 (2m)). And the data can be summed up or recorded
・ Use only the output cable of Mitutoyo specific accessories. The use of an improper
cable or deteriorated cable may disable data output.
・ Prior to data output carefully read the user’s manual of the data processor to use it
correctly.
4.1 Cable Connection
Remove the output connector cap, and then connect the instrument to the data processor
by using a connecting cable. Insert the cable securely to the end, in the direction as
shown.
・ Store the removed cap, taking care to prevent loss.
・ Install the direction of output pin correctly.
・ Be sure to attach a cap to the connecting cable when not in use.
To Next Page
Loading...
