No. 99MAH040B
3.3.2 RES: Resolution
The resolution of the display can be changed.
Selecting the resolution
3. Press the upper right key in the measurement mode to move the setup mode.
4. Press the lower left or lower right key to move the blinking cursor to "RES".
5. Press the center key to set the resolution.
6. Press the lower left or lower right key to switch the resolution.
7. Press the center key to set the resolution and the mode returns to the parameter
setting. (Refer to "3.3 Setup Mode".)
・ The preset values (P1, P2, P3) and the tolerance values (upper and lower limits) will be
calculated automatically according to the resolution. Check the values after changing
the resolution, since the conversion error or overflow error (Err95) may occur.
・ Press the upper left key to cancel the operation.
・ When the unit is switched, the resolution will be automatically changed accordingly.
Check the resolution after switching the unit.
To Next Page
Loading...
