No. 99MAH040B
・ To use the data output function properly, refer to the operation manual of the data
processor to be connected.
・ When inputting a data output request (REQ) from a data processor, the spindle must
be stopped. Otherwise, this instrument may output wrong data or may not output.
・ If this instrument receives data output request (REQ) signals repeatedly at short
intervals, it may not output a data.
3.2.6 Data save/Data load
Up to 9 data can be stored in the internal memory of this instrument.
The saved measurement values can be displayed by loading operation. The following data
can be also checked by loading the data.
・ For the maximum value among the saved measurement values, "Max" will be
displayed.
・ For the minimum value among the saved measurement values, "Min" will be
displayed.
・ The result of tolerance judgment for the saved values will be displayed while the
tolerance judgment is enabled. (Refer to "3.3.1 TOL: Tolerance judgment".)
Data save
Press the lower right key in the measurement mode.
When a data processor is not connected, data will be saved at the time when the
displayed value is held. Data save will not be performed when the hold status is
released.
When a data processor is connected, data will be saved at the time when the displayed
value is output.
Data load
1. Press the upper left key in the measurement mode, to enter into the data load mode.
"H" will blink, and the last saved value will be displayed.
2. Press the lower left or the lower right key, to change display value. The data number
displayed in the upper right of the display unit indicates the order of saving. The larger
the number is, the more recent the measurement value is.
Stopping the data load
Press the upper right key to restore the normal mode after deleting all the saved
measurement values.
・ When data save is executed while 9 data are already saved, the data number "1",
which is the oldest data, will be deleted. When a data is deleted, the data numbers
descend and the measured value to be saved this time will be numbered "9".
・ When data load is stop, the saved measurement values will be deleted. Therefore,
make a note of data if necessary.
・ Set the followings before performing data save or data load, because all the saved
measurement values will be deleted, if any of the following operation is performed
besides data load stopping:
Selecting the preset values
Selecting the tolerance judgment setting
To Next Page
Loading...
