Mitutoyo ID-C112GXB - Page 23

No. 99MAH040B
3-8
 Changing the resolution
 Shifting into PC communication status
 Power off (auto-off)
 Switching units
・ Even when shifting from the minimum value detection mode to the data load, the
normal mode will be restored when data load is stop.
・ When the maximum and the minimum values are the same, both "Max" and "Min" will
be displayed.
・ If there are multiple maximum or minimum values, "Max" or "Min" will be displayed
respectively with each value.
・ If data load is executed when no data is saved, "0" as data number and "------" as
measurement value will be displayed.
TIP
・ The following describes some examples of the data number
 When the number of saved measurement data are less than 9
 When the number of saved measurement data are 9 (maximum number) or more
Data
No.
9
8
7
6
5
4
3
2
1
Measurement
value (mm)
Data
save
7.903
8.025
7.979
7.926
7.908
8.014
8.002
7.941
7.910
8.072
Data save 9th
Data save 10th
Data save 11th
8.025
7.979
7.926
7.908
8.014
8.002
7.941
7.910
8.072
7.980
Destruction
Destruction
・・・
Data
No.
9
8
7
6
5
4
3
2
1
7.979
7.926
7.908
8.014
8.002
7.941
7.910
8.072
7.980
Measurement
value (mm)
Data
No.
9
8
7
6
5
4
3
2
1
Measurement
value (mm)
Data
save
Data
save
Data
No.
Measurement
value (mm)
9
8
7
6
5
4
3
2
1
-
-
-
-
-
-
-
-
7.980
Data
save
・・・
Data save 1th
Data save 2th
Data save 9th
Data
save
Data
save
Data
No.
Measurement
value (mm)
9
8
7
6
5
4
3
2
1
-
-
-
-
-
-
-
8.072
7.980
Data
No.
Measurement
value (mm)
9
8
7
6
5
4
3
2
1
7.979
7.926
7.908
8.014
8.002
7.941
7.910
8.072
7.980