Mitutoyo ID-C112GXB - 3.3.5.4 All Reset

No. 99MAH040B
3-32
3.3.5.4 RESET(4): All reset
It restores the factory default.
 Executing all reset
1. Press the upper right key in the measurement mode to move the setup mode, and
select OTHER functions. (Refer to "3.3.5 OTHER: Other functions".)
2. Press the lower left or lower right key until "RESET" is blinking.
3. Press the center key to move the all reset setting.
4. Press the lower left key to select "YES".
5. Press the center key, then "YES" will be displayed again.
6. Press the center key to execute all reset.
The display turns off shortly, and restores the display of the time when the battery
is installed.
IMPORTANT
・ The setting before executing all reset cannot be restored.
Factory default
Setting items
Settings
Preset
Preset No. (P1/P2/P3): P1
Preset values (P1/P2/P3): Zero for all
Unit
mm (for inch models: in)
Center position of the analog bar
Centered at zero
Tolerance judgment
OFF
Tolerance judgment (upper limit/lower limit):
Zero for all
Resolution
0.001mm (0.00005in)
Analog bar graduation
Auto
Key-lock
OFF
All key function: Enabled
Analog bar display
ON
FAST mode
OFF
Data save
Discard all saved measurements
Parameter-lock
OFF