No. 99MAH040B
3.3.5.1 PC(1): PC communication
This instrument can set up or change various items with special software, if it connects to
Personal computer with a Parameter setup kit (optional accessory).
Enabling PC communication
1. Connect a Parameter setup kit.
2. Press the upper right key in the measurement mode to move the setup mode, and
select OTHER functions. (Refer to "3.3.5 OTHER: Other functions".)
3. Press the lower left or lower right key until "PC" is blinking.
4. Press the center key to move the PC communication setting.
5. Press the lower left key to select "ON".
6. Press the center key to start communication with the PC.
When the communication is started, "PC con" will be displayed.
・ Press the upper left key to cancel the communication with the PC.
・ Remove the cap of the output connector, and securely connect the cable.
・ Do not disconnect the Parameter setup kit while communicating with the PC.
・ When communication with PC is finished, the measurement mode will be restored.
・ For details of communication with the PC, refer to the operation manual supplied with
the Parameter setup kit.
・ When the mode is shifted into PC communication, all the measurement values saved
with the data save function will be deleted.
Enabling PC communication
To Next Page
Loading...
