MODE V6 - 3 Documentation; 4 Ensure availability of tools and equipment; 5 Allow sufficient time; 6 Prevent unauthorized access to the site

7/2015
This document and the information contained herein, is the exclusive property of MODE. And represents a nonpublic,
confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, or otherwise employed in
any manner. whatsoever without the express written consent of MODE. Copyright © (2016) MODE. Allrights reserved.
18 / 82
3
Documentation
At handover, check with your supplier that you have received all of
the documents that you are supposed to have and that they
correspond to the product.
Owners SHALL ensure that all product documentation is available
and is in the agreed language.
4
Ensure availability of tools and equipment
The owner must ensure that tools and equipment are available for
installation, in accordance with the sales contract.
Lifting equipment, man lifters and test loads may be required.
Hand lines, securely attached to the building structure, should. be
used for lifting or lowering materials and tools. Use proper safety
equipment to prevent objects from falling when working in high
places.
5
Allow sufficient time
Owners must ensure that sufficient time has been reserved for
installation and testing.
6
Prevent unauthorized access to the site
Owners must prevent unauthorized persons and bystanders from
walking on or below the work site.
Ensure that the secured area is spacious enough to prevent injuries
which could occur as a result of falling components or tools.
7
Minimize the risks of moving machinery
Make sure that there is no possibility for personnel or body parts to
be struck, crushed
Or compressed by moving machinery.
Owners must secure the area so that installation personnel are not
at risk from the movements of machines, automatic doors or
adjacent hoists at the installation site.
Ensure that machinery and equipment cannot start accidentally and
cannot move during installation and servicing. Maintain sufficient
free space in the working area to reduce risks. Moving parts should
be properly shielded with guards to prevent
entrapment. Safety devices must never be overridden.
Be prepared in case equipment moves in the wrong direction during
testing.
8
Ensure that the support structure is prepared for the product
Owners must ensure that the support structure which the product is
attached to is designed for the load of the product and meets the
specific requirements and tolerances.