MODE V6 - 2 Pay special attention to all safety-critical components; 3 Check the environmental and space requirements; 6.2 Checks before first run; 1 Lubrication

7/2015
This document and the information contained herein, is the exclusive property of MODE. And represents a nonpublic,
confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, or otherwise employed in
any manner. whatsoever without the express written consent of MODE. Copyright © (2016) MODE. Allrights reserved.
35 / 82
2
Pay special attention to all safety-critical components
Note any damaged parts from installers or in shipping.
3
Check the environmental and space requirements
Check that no permanent or temporary obstructions are in the way
of the hoist when the hoist is operated.
6.2 Checks before first run
1
Lubrication
Check the lubrication of chain and the traveling and hoisting gear.
Check that traveling gear box is vented.
2
Bolted connections
Check bolted connections. Bolts need to be torqued with a proper
torque wrench. Check installation of jam and locking nuts. Refer to
chapter “Tightening torques”.
3
Electrical connection
With the product disconnect OFF, check the proper electrical
grounding of the product.
Check that the connections of electrical devices comply with the
wiring diagrams and meet local requirements. In particular, check
connections that affect the safety and controlling of the equipment.
Check the condition of wiring and connections.
4
Chain
Check that the chain has not been damaged during transport or
twisted.
Check the fixing of chain ends.
Check that the chain is correctly lubricated according to the
instructions given in chapter Lubrication.
5
Hook
Check the hook. Check to ensure that the hook safety latch is on
the hook, is in good condition and closes automatically. Check that
the hook forging rotates freely. Measure the dimension of hook
opening of the suspension hook and hook block. Note it for a
follow-up.