This document and the information contained herein, is the exclusive property of MODE. And represents a nonpublic,
confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, or otherwise employed in
any manner. whatsoever without the express written consent of MODE. Copyright © (2016) MODE. Allrights reserved.
Note: The value of the factory setting is 1,4 x the nominal load because friction
lining is not run in yet
Note: To adjust the slipping clutch, it is recommended to use the chain force
measuring device. Never the less, it is possible to use loads.
8.4 Lubrication
8.4.1 General lubrication instructions
Note: The bearings in the product have lifetime lubrication. There is no
need to add lubricant to the bearings | under normal operating
conditions.
The following table provides advice on the lubrication procedures to be followed.。
Usage of a low grade or incompatible lubricant can damage the
gearing or bearings. Use only lubricants recommended by the
product’s manufacturer. See the lubricant tables for more
information.
Use only fresh oils/greases. Different kinds of greases shall not be
mixed up.
Information about each chemical’s safe handling, risks and
handling as waste are described in the Safety Data Sheet that is
available from manufacturer of the lubricant.
Note: equipment may have synthetic lubricant as a factory installed
lubricant. Please refer to order confirmation.
Handle lubricants carefully. Prevent leakages to waters, sewers,
cellars and other closed places.
Keep lubricants away from heat and open fires. Do not smoke.
Avoid contact with skin. Protection gloves and safety goggles shall
be worn when handling lubricants. Hands shall be washed
thoroughly after lubrication.
To Next Page
Loading...
