MODE V6 - 9 Check the power supply is compatible; 10 Safety devices must be restored to operational status; 11 Check the environmental and space requirements; 12 Check for dimensional conformance

7/2015
This document and the information contained herein, is the exclusive property of MODE. And represents a nonpublic,
confidential and proprietary trade secret that may not be reproduced, disclosed to third parties, or otherwise employed in
any manner. whatsoever without the express written consent of MODE. Copyright © (2016) MODE. Allrights reserved.
19 / 82
9
Check the power supply is compatible
Check that the supply voltage and frequency match the
requirements of the product.
Check that the installed bus bars are suitable for the product.
10
Safety devices must be restored to operational status
Ensure that any safety devices which have been bypassed for
testing purposes have been restored to full operational status
before allowing the product to be used for normal operation.
11
Check the environmental and space requirements
Ensure that the operating environment and space reserved for the
product in the operating location is suitable for all functions of the
product.
12
Check for dimensional conformance
Immediately following installation and prior to commissioning,
check that the supplied parts conform to the drawings, instructions,
parts lists and structural measurements.
Discuss any non-conformance with the supplier immediately.
13
Ensure that there are no hazards from loose items
Items which are not properly secured to the product, such as tools
or detached components, could move or fall accidentally, with
potentially serious consequences.
When dismantling the product, lower components to the ground at
the earliest practical opportunity.
14
Ensure that there are no electrical hazards
Check for any electrical hazards in and around the working area
and take appropriate steps to minimize them. Only properly trained
personnel may perform electrical work on the product and they
must use safe methods at all times.
15
Take precautions if welding is done at the site
If there is a need for welding to be done at the site:
Provide suitable fire extinguishers.
Do not allow the product structure or any of the components to be
used for grounding.
The hook must be isolated to protect it from providing a ground prior
to welding. Do not weld on the hook.
2.9 Safety during Usage
This chapter only presents the owner's responsibilities towards the operator with regard to
equipment usage. See instructions for the operator for detailed safety information concerning
actual usage of the equipment.