Appendix
01/02 AWB8230-1415GB
210
C070 Programming through:
• 02: LCD keypad
• 03: RS 485 serial interface
• 04: Optional module in slot 1
• 54: Optional module in slot 2
02 a current version: ftp://ftp.moeller.net/DRIVES/
DOCUMENTATION/AWB/index.html
C071 Baud rate
• 03: 2400 bit/s
• 04: 4800 bit/s
• 05: 9600 bit/s
• 06: 19200 bit/s
04
C072 Address, value 01 to 32 1
C073 Data word length: 7 or 8 bit 7
C074 Parity
• 00: None
• 01: Even
• 02: Odd
00
C075 Stop bits: 1 or 2 1
C078 Transmission waiting time [ms] 0
C081 Compensation of setpoint signal at terminal O Depending
on inverter
model
62
C082 Compensation of setpoint signal at terminal OI 62
C083 Compensation of setpoint signal at terminal O2 62
C085 Thermistor matching 105 82
C086 Offset, AM terminal [V] 0.0 58
C087 Gain, AMI terminal 80 59
C088 Offset, AMI terminal Depending
on inverter
model
59
C091 Debug mode 00 168
C101 Use saved UP/DWN setting
• 00: Use PNU A020
• 01: Use saved UP/DWN frequency
00 85
C102 Reset signal
• 00: On rising edge
• 01: On falling edge
• 02: On rising edge, only on fault
00 78
C103 Behaviour with reset
• 00: 0 Hz start
• 01: Synchronization to motor speed
00 78
C111 Overload alarm threshold [A] I
e
105
C121 Zero-point matching, terminal O Depending
on inverter
model
62
C122 Zero-point matching, terminal OI 62
C123 Zero-point matching, terminal O2 62
PNU Function Units Default Page Setpoint
For Moeller Electric Sales and Support call KMparts.com (866) 595-9616
To Next Page
Loading...
