01/02 AWB8230-1415GB
Standard form for user defined
parameter settings
209
C028 Output, AM output
• 00: Output frequency, PWM signal
• 01: Output current
• 02: Torque, SLV control only
• 04: Output voltage
• 05: Inverter input power
• 06: Thermal load ratio
• 07: Ramp frequency
00 58
C029 Output, AMI output (values a PNU C028) 00 59
C031 Digital output 11
• 00: Make contact
• 01: Break contact
00 101
C032 Digital output 12 (values a PNU C031) 00 101
C033 Digital output 13 (values a PNU C031) 00 101
C034 Digital output 14 (values a PNU C031) 00 101
C035 Digital output 15 (values a PNU C031) 00 101
C036 Relay terminals K11-K12, signalling relay
(values a PNU C031)
01 118
C040 Overload alarm signal
• 00: Always
• 01: Only at constant speed
01 105
C041 Threshold for overload alarm at digital outputs 11 to 15 [A] I
e
105
C042 Frequency from which FA2 is switched on during
acceleration
[Hz] 0.00 103
C043 Frequency from which FA2 is switched off during
deceleration
[Hz] 0.00 103
C044 PID control deviation (from the maximum setpoint
value)
[%] 3.0 106
C045 Frequency from which FA3/FA5 is switched on during
acceleration
[Hz] 0.00 103
C046 Frequency from which FA4/FA5 is switched off during
deceleration
[Hz] 0.00 103
C055 Torque threshold, clockwise in drive mode [%] 100 110
C056 Torque threshold, anticlockwise in regenerative mode [%] 100 110
C057 Torque threshold, anticlockwise in drive mode [%] 100 110
C058 Torque threshold, clockwise in regenerative mode [%] 100 110
C061 Thermal overload warning [%] 80 115
C062 Fault message, digital, to digital outputs
• No output
• 3-bit encoded output to terminals 11 to 13
• 4-bit encoded output to terminals 11 to 14
00 116
C063 Frequency threshold for digital output ZS [Hz] 0.00 109
PNU Function Units Default Page Setpoint
For Moeller Electric Sales and Support call KMparts.com (866) 595-9616
To Next Page
Loading...
