Scripting
124 5016072 A
Using Repeats
Use the Begin/End Repeat commands to repeatedly execute a set of
commands. Specify the number of required repetitions when you add
the Begin Repeat command. The block of commands between the
Begin Repeat command and the End Repeat command runs the
specified number of times.
The example in Figure 4-15 shows how to set up a repeat for running
three plates.
Figure 4-15 Example command script with a repeat.
Repeated
commands.
Signals the start of
the repeated
commands and is set
Signals the end of the
repeated commands.
Note: Nesting of repeat blocks is not supported. Also, syntax
checking does not detect an unpaired Begin Repeat or End Repeat
as an error because the syntax check validates only individual
commands.
StakMax-UG-5016072A.book Page 124 Friday, October 21, 2011 3:51 PM
To Next Page
Loading...
