5016072 A 13
2
Installation and Set Up
Installing the StakMax
®
microplate handler involves unpacking the
equipment and attaching it to a microplate instrument. Setting up the
StakMax microplate handler involves installing the StakMax USB driver
and aligning the microplate handler drawer with the StakMax
microplate gripper.
This section contains the following topics:
• Unpacking the System on page 15
• Connecting the Baseplate on page 17
• Installing or Replacing a Barcode Reader on page 47
• Installing the StakMax Driver on page 49
• Aligning the StakMax Gripper on page 58
• Performing a Gripper Functional Check on page 78
Note: The StakMax USB driver enables the StakMax Software, which
is installed with the SoftMax
®
Pro Software version 6.1 (or later).
StakMax-UG-5016072A.book Page 13 Friday, October 21, 2011 3:51 PM
To Next Page
Loading...
