APPENDIX G
84
Setup and Installation
1. Place software into the CD-RW drive.
2. Select appropriate language.
3. Follow instructions on display for completion of software installation.
4. Place dongle into any USB port.
5. Connect the Network cable from the PC to the network receptacle.
6. Request the facility network management team install the proper IP addresses, subnet mask, and default
gateway for their network on the review workstation.
7. Connect the crossover network cable to the network connector on the Z200+ and the other end to the
network connector on the back of the PC.
NOTE: The serial connector is not used.
NOTE: When setting up a network share folder ensure that the path has adequate security permissions and
sharing options are set appropriately.
NOTE: When an archive is in use at another location, a prompt will signal that it cannot be opened. Only one
archive can be active at a time.
To Previous Page
Loading...
