Mortara X-Scribe - Z200+ Thermal Printer Specifications; Input and Output Descriptions

APPENDIX F
75
Z200+ Thermal Printer Specifications
Feature Specification*
Instrument Type
Thermal printer
Paper Type
8 ½” x 11”, cued, perforated, Z-fold with full grid or A4
Recording Technique
Computer controlled, thermal dot array, 8 dots/mm
Writer Speeds
5, 10, 25, or 50 mm/sec, computer controlled
External Ports and Data
Interfaces
Networking capability to allow high-speed data transfer for printing
External RJ-45 connector
Chassis Leakage Current
Meets or exceeds requirements of ANSI/AAMI EC11
Power
100-240 VAC at 50/60 Hz
Weight
9 lbs. or 4.09 kg
Dimensions H x W x D
4” x 16” x 13” (10 cm x 41 cm x 33 cm)
Fuses
T-Type 1 Amp, 250 V
Special Functions
LAN communication that provides continuous printing
* Specifications subject to change without notice
Input and Output Descriptions
Feature Description
AC Power
The Z200+ thermal printer operates on 120/240 VAC at 50/60 Hz. Power is
supplied as soon as the AC power cord is connected to an AC power outlet.
Power-On Indicator
This indicator will illuminate in green when AC power is applied.
Form Feed/Reset
Button
The form-feed pushbutton is a momentary contact switch that advances the paper
until an infrared, reflective sensor detects a “cue mark” on the printing side of the
paper. This button will reset the thermal printer when it is depressed for a period of
seven seconds.
Hard-Copy Printout
The Z200+ thermal printer uses 8 1/2” x 11” sheets of Z-folded, thermal-sensitive
paper with cue marks. Printing speeds are 10, 25, and 50 mm/second. Dot density is
eight dots per millimeter or 203.2 dpi.
Paper Out/Writer Error
Indicator
This indicator will illuminate in green when writer-error conditions are detected.
Errors include not detecting a cue mark at the expected time (due to a paper jam or
drive system failure) and detecting a cue mark longer than expected. The writer
error will remain illuminated until the form-feed button is depressed.