TREADMILL/ERGOMETER HOOKUP
APPENDIX E
69
X-Scribe to Treadmill Hookup Instructions
1.Connect one end of the X-Scribe-to-treadmill interface cable to the top 9-pin serial Com 1 port on the back
of CPU, and the other end to the 9-pin serial port on the treadmill.
2.Connect the treadmill power cord to a dedicated circuit as recommended by the treadmill manufacturer.
3.Turn the treadmill power switch ON.
4. Turn the X-Scribe ON.
NOTE: Do not connect the treadmill to the patient isolation transformer. It is important that the treadmill
has its OWN SOURCE OF UNSHARED POWER to avoid an interruption to the power supply to the X-
Scribe. The treadmill should have its own circuit and fuse/breaker in a local power distribution box.
NOTE: Hookup may vary depending on treadmill model version.
X-Scribe to Ergometer Hookup Instructions
1. Connect one end of the X-Scribe-to-ergometer interface cable to the top 9-pin serial Com 1 port on the
back of CPU, and the other end to the 9-pin serial port on the ergometer.
2. Connect the ergometer power cord to a dedicated circuit as recommended by the ergometer manufacturer.
3. Turn the ergometer power switch ON.
4. Turn the X-Scribe ON.
NOTE: Do not connect the ergometer to the patient isolation transformer. It is important that the
ergometer has its OWN SOURCE OF UNSHARED POWER to avoid an interruption to the power
supply to the X-Scribe. The ergometer should have its own circuit and fuse/breaker in a local power
distribution box.
NOTE: Hookup may vary, depending on ergometer model version.
NOTE: When using the Ergoline ergometer with NIBP, you must select the 900S from the equipment
selection in the Settings menu.
To Next Page
Loading...
