SECTION 4
34
Using Report Manager
Patient Data
If patient demographic data has not been entered, enter it now by clicking Patient Data. The Patient
Demographics pop-up window will appear.
Print Report
Use the Print Options drop-down menu to choose the desired printer. Check the Grid box to include grid when
printing to a laser printer. Using the up/down arrow keys, choose the number of copies for each report (Summary,
Trends, Average QRS, 12-Lead ECG, Rhythm Events) and click Print Report. Reports can also be printed from
the directory at a later date or time.
NOTE: The final report when saved must have at least 1 copy selected in order for the report to be stored
in PDF, XML, TIFF, or DICOM.
Quick Print
Quick Print buttons provide an alternative means to printing the following reports:
Patient ID: Patient demographics.
Summary: Summary report page, plus one average beat per lead from pre-exercise, peak-exercise, the
point of maximum ST depression two minutes into recovery, and any documented events.
Trends: Trends of the ST slope, ST level, HR, systolic and diastolic blood pressure, Double Product,
speed and metabolic equivalents. Trends of the ST slope and ST level print for all leads defined as valid in
the configuration.
Average QRS: One average complex per lead for each minute or stage of exercise and recovery. 12
average complexes for all events, RPE ratings, automatic ECGs, manual ECGs, and arrhythmia episodes
are included. Select the printout by stage or by minute using the drop-down menu.
12 Lead ECG: 12-lead ECGs acquired during the Exercise and/or Recovery phase.
Arrhythmias - All acquired arrhythmia events.
Post-Processing
Click Rhythm Events to display a snapshot of all events and captured arrhythmias. Use the buttons provided to
Print, Re-label, or delete each snapshot. When a snapshot is deleted, a red message is displayed across the snapshot.
All deleted snapshots are removed when the user exits the screen. Select OK to exit and save all changes or select
Cancel to exit without saving changes.
To rescan the stress test using a different ST measuring point, use the up/down arrows to define a new J-ST value
and click ST Modify. All ST measurements will be adjusted to reflect the new measurement point.
To Next Page
Loading...
