Mortara X-Scribe - Page 67

SECTION 5
49
10. Conclusions1.txt
NOTE: Up to 20 Template Summary reports can be created with each having their own particular label if
so desired. The label will be formulated under the progressive folders of Conclusions2.txt,
Conclusions3.txt, and so on.
a. To create a title to be included in the drop-down window (such as Normal study), type “#”
followed by the desired title on the first line (“#Normal study). The title will display in the drop-
down window. The title is not included in the report information which follows on the next line.
b. Enter desired template summary information by using various XML data points from the XML
file structure. Data points will automatically fill in at the end of the test. Data is available for
edit/review from Report Manager, or from a remote review workstation.
Example template summary with XML data points:
Patient was tested using <ProtocolName> protocol for a duration of <ExerTime>. A maximum
heart rate of <MaxHr> was obtained with a maximum blood pressure of <MaxSbp>/<MaxDbp>.
ST Changes of <StDepValue> <StDepUnit> were noted in <StDepLead> at <StDepTime> of the
exercise.
Template summary after auto fill:
Patient was tested using BRUCE protocol for a duration of 14:22 min. A maximum heart rate of
168 was obtained with a maximum blood pressure of 164/85. ST Changes of -2.2 mm were noted
in V4 at 14:10 of the exercise.
Data points may be the following:
<ProtocolName> protocol name
<ExerTime> total exercise time
<MaxSpeed> maximum speed achieved on the treadmill
<MaxGrade> maximum elevation of the treadmill
<MaxPower> maximum WATTs achieved on the ergometer
<MaxHr> maximum heart rate obtained
<TargetHrPerc> predicted target heart rate
<MaxHrTime> time maximum heart rate was achieved
<MaxSbp> maximum measured systolic blood pressure
<MaxSbpTime> time maximum systolic blood pressure was acquired
<MaxDbp> maximum measured diastolic blood pressure
<MaxDbpTime> time maximum diastolic blood pressure was acquired
<LeadsOver100> leads measuring over 100 µV
<StEleUnit> ST elevation measured unit in mm or µV
<StEleValue> ST elevation value
<StEleLead> measured ST elevation value lead
<StEleTime> time maximum ST elevation was acquired
<StDepUnit> ST depression measured unit in mm or µV
<StDepValue> ST depression value
<StDepLead> measured ST depression value lead
<StDepTime> measured ST depression value lead