Digital Input 120/230V Module
7-8
Digital Input 120/230V Module Specifications
High Voltage 16DI Module
Total Number of Inputs 16 DI
Input Characteristics IEC 61131-2 Type 1
Input Arrangement Two isolated groups of 6 inputs and one isolated group of 4 inputs.
AC Input Frequency 47 – 63 Hz
AC Input Change Delay Maximum 25.0 msec
Max. DC Input Voltage Max. ±264 V DC (relative to input common)
DC Input Pulse Width Minimum 7.0 msec @ 230 V DC
“ON” DC Voltage Range +79.0 V DC to +264.0 V DC, -79.0 V DC to -264.0 V DC
“OFF” DC Voltage Range -40 to +40 V DC
“ON” AC Voltage Range 79 to 264 V AC (RMS)
“OFF” AC Voltage Range 0 to 40 V AC (RMS)
Input Current At 110V DC 1.0 to 3.0 mA
At 230V DC 0.4 to 2.0 mA
At 110V AC > 2.0 mA RMS
At 230V AC > 3.0 mA RMS
Permitted Voltage Difference
Between Groups
2.5 kV RMS
Input Filtering 0 to 50.8 msec (DC, programmable in 0.2 msec steps)
Note: Minimum effective filter value is 7.0 msec.
Diagnostic LEDs Status LED per each input, module error LED
User Connection 3 Terminal Blocks (5.00mm pitch), Maximum 14 AWG
Cable and TB Holder 30-wire cable braid with Terminal Block holder connector, 20 AWG
wires
Module Replacement Hot swap replacement – module extraction/insertion under voltage
Input Isolation 2.5 kV RMS between input and module logic per IEC60255-5
Input Insulation Insulation resistance 100 MΩ @ 500 V DC
Operating Voltage 10.8-16 V DC and 3.3 V DC ±10% (from the motherboard connector)
Power Consumption Refer to Appendix D: ACE3600 Maximum Power Ratings.
Dimensions 37 mm W x 225 mm H x 180 mm D, (1.5“ W x 8.7“ H x 7.1“ D)
Weight approx. 0.367 kg (0.80 lbs)
Specifications subject to change without notice.
To Next Page
Loading...
