Motorola ACE3600 RTU - Front Panel Communication Ports

CPU Module
4-2
The CPU panel includes status LEDs, user LEDs, communication port LEDs, two pushbuttons,
and communication ports. The panel is covered by the module door.
Figure 4-2 provides a detailed view of the CPU front panel.
Pushbuttons
CPU Status
LEDs
Port
LEDs
User
LEDs
Serial 1
Serial 2
Plug-in 1*
Plug-in 2*
Host (Model 3680)USB 1,2 Type A
Ethernet 1(Model 3640, 3680)
Device USB 1 Type B (Model 3680)
*Optional
PWR
USR1
USR2
USR3
USR4
LNK1
LNK2
Tx
Rx
CM
Tx
Rx
CM
Tx
Rx
CM
LNK
Rx
LNK
Rx
Tx
Rx
CM
LNK
ERR
RST
APPL
CONF
P1
Tx
S1
S2
E1
E2
P2
H1
D1
Figure 4-2 ACE3600 CPU (Models 3610/3640/3680) – Front Panel
Front Panel
Communication Ports
The CPU module includes several communication ports:
On Board ports:
• USB Host 1/2 (HU1/HU2) - USB Type A host full speed ports for MDLC over IP
communication via the MotoTrbo digital mode radio system (up to two radios
attached to two USB host ports at one time).
No USB devices or USB Hubs other than
MotoTrbo radios are supported.
• Serial 1 (SI1) – RS232/RS485 serial port (configurable)
• Serial 2 (SI2) – RS232 serial port
• Ethernet (Eth1) - 10/100BaseT Ethernet port (CPU 3640 or 3680 only)
• DU1 – USB device port, Type B connector (for connection to the STS PC)