Installation
2-12
4) Hang the metal chassis on brackets so that the two teeth of the metal chassis hook onto the
groove of the brackets. (See Figure 2-14.)
5) Using two M4 screws (not supplied) with head size DIN 7981C/ST4, 2x38mm screws,
secure the top and bottom of the frame to the left bracket. Repeat for the right bracket.
Figure 2-14 RTU Metal Chassis Installation
Mounting the ACE3600 NEMA 4 Housing on a Wall
The following screw mount installation procedure should be used to install ACE3600 frames in
NEMA 4 housing on a wall.
For convenient installation of the ACE3600 RTU with the NEMA 4 housing, allow an
additional 6 cm (2.4") (in W, H) and 7 cm (2.75") (in D) around the housing.
Four mounting brackets are provided, one in each corner of the RTU, for wall mounting the
RTU housing (see Figure 2-15 through Figure 2-17). Figure 2-15 and Figure 2-16 show the
distances between the bracket holes.
To Next Page
Loading...
