Motorola LEX L10 - Cell Broadcasts; Wireless Local Area Networks; Scanning and Connecting to a WiFi Network

8.1.7 Cell Broadcasts
Cell Broadcasts allows emergency alert messages to be broadcast simultaneously from a service provider to multiple
users in within a designated geographical area. Broadcasts are often used for weather updates, regional events, traffic
conditions and other services.
When and where to use: Use this procedure to enable emergency alert messages by cell broadcasts on the LEX L10.
Procedure:
1
Tap .
2
Tap .
3 Tap More... .
4 Tap Cell broadcasts.
5 Check the emergency alert types you want to receive.
6
Tap .
8.2 Wireless Local Area Networks
Wireless local area networks (WLANs) allow the LEX L10 to communicate wirelessly inside a building. Before using
the LEX L10 on a WLAN, the facility must be set up with the required hardware to run the WLAN (sometimes
known as infrastructure). The infrastructure and the LEX L10 must both be properly configured to enable this
communication.
See the documentation provided with the infrastructure (access points (APs), access ports, switches, Radius servers,
etc.) for instructions on how to set up the infrastructure.
Once the infrastructure is set up to enforce the chosen WLAN security scheme, use the Wireless & networks
settings to configure the LEX L10 to match the security scheme.
The LEX L10 supports the following WLAN security options:
•
Open
• Wireless Equivalent Privacy (WEP)
• WiFi Protected Access (WPA)/WPA2 Personal (PSK)
• Extensible Authentication Protocol (EAP)
- Protected Extensible Authentication Protocol (PEAP) — with Microsoft Challenge-Handshake Authentication
Protocol version 2 (MSCHAPv2) and Generic Token Card (GTC) authentication.
- EAP-Transport Layer Security (TLS)
- EAP-TTLS - with Password Authentication Protocol (PAP), MSCHAP and MSCHAPv2 authentication
The Status bar displays icons that indicate WiFi network availability and WiFi status.
Note: Turn off WiFi when not using it, to extend the life of the battery.
8.2.1 Scanning and Connecting to a WiFi Network
Procedure:
1
Tap .
2
Tap .
Wireless | 127
MN001456A01-A | February 2015 | Send Feedback