Motorola LEX L10 - Adding a WiFi Network; Manually Adding a WiFi Network

• If required, in the Identity text box, enter the username credentials.
•
If desired, in the Anonymous identity text box, enter an anonymous identity username
• If required, in the Password text box, enter the password.
9
Tap
.
8.2.3 Adding a WiFi Network
You can add a WiFi Network that is currently out of range or indiscoverable.
Procedure:
1
Tap .
2
Tap .
3
Tap WiFi.
4 Slide the WiFi switch to the On position.
5 Tap +.
6 Enter network SSID and select Security.
7 Tap Save.
The LEX L10 connects to the wireless network.
8
Tap .
8.2.4 Manually Adding a WiFi Network
Manually add a WiFi network if the network does not broadcast its name (SSID) or to add a WiFi network when out
of range.
Procedure:
1
Tap .
2
Tap .
3
Tap
WiFi.
4 Slide the WiFi switch to the ON position.
5 Tap + in the bottom right corner of the screen.
By default, the network Proxy is set to None and the IP settings is set to DHCP.
6 In the Network SSID text box, enter the name of the WiFi network.
7 In the Security drop-down list, select the type of security. Options included are:
• None
• WEP
• WPA/WPA2 PSK
• 802.1x EAP
8 If the network security is None, tap Save.
9 If the network security is WEP or WPA/WPA2 PSK, enter the required password and then tap Save.
10 If the network security is 802.1x EAP enter the information below and then tap Save:
•
Tap EAP method drop-down list and select PEAP, TLS or TTLS.
• Tap Phase 2 authentication drop-down list and select an authentication method.
• Tap CA certificate and select a Certification Authority (CA) certificate.
130 | Wireless
Send Feedback | February 2015 | MN001456A01-A