Motorola LEX L10 - Powering Off the LEX L10; Entering and Exiting the Suspend Mode; Setting Time Out to Enter Suspend Mode

2.6 Powering Off the LEX L10
When and where to use: Use this procedure to power off the LEX L10:
Procedure:
1 Press and hold the Power button until the Power Button menu appears.
Figure 15: Selecting Power Off
2 Tap Power off and then OK.
Your phone will shut down is displayed on the screen.
2.7 Entering and Exiting the Suspend Mode
Suspend mode (also known as sleep mode) is a low-power mode of operation that helps reduce electrical power
consumption by shutting down parts of the LEX L10 that are not in use. The LEX L10 goes into Suspend mode when
the Power button is pressed or after a time out period of inactivity.
When and where to use: Use this procedure to enter and exit Suspend mode:
Procedure:
1 To enter Suspend mode, press and release the Power button.
The LEX L10 screen turns off.
Note: In Suspend mode, the following items continue to operate:
• Power button
• PTT Button (if set to be used)
•
Notification LEDs
• Wireless communication.
2 To exit Suspend mode, press and release the Power button.
2.7.1 Setting Time Out to Enter Suspend Mode
When and where to use: Use this procedure to set the period of inactivity before suspend mode occurs:
Procedure:
1 From the Home screen, tap: Settings → Display → Sleep.
2 Check the inactivity duration before Suspend mode becomes active.
38 | Getting Started with the LEX L10
Send Feedback | February 2015 | MN001456A01-A