6 For open networks, tap profile once or press and hold and then select Connect to network or for secure networks
enter the required password or other credentials then tap Connect. See technical support for more information.
The LEX L10 obtains a network address and other required information from the network using the dynamic host
configuration protocol (DHCP) protocol.
7 In the WiFi setting field, Connected displays indicating that the LEX L10 is connected to the WLAN.
8.2.2 Configuring a WiFi Network
Procedure:
1
Tap .
2
Tap .
3
Tap WiFi.
4 Slide the switch to the ON position.
The LEX L10 searches for WLANs in the area and lists them on the screen.
5 Scroll through the list and select the desired WLAN network.
6 Tap the desired network.
If the network security is Open, the LEX L10 automatically connects to the network. For all other network
security a dialog box appears.
Figure 95: WLAN Network Security Dialog Boxes
Note: By default, the network Proxy is set to None and the IP settings is set to DHCP.
7 If the network security is WEP or WPA/WPA2 PSK, enter the required password and then tap Connect.
8 If the network security is 802.1x EAP, enter the information below and then tap Connect:
•
Tap the EAP method drop-down list and select PEAP, TLS or TTLS.
• Tap the Phase 2 authentication drop-down list and select an authentication method.
• If required, tap CA certificate and select a Certification Authority (CA) certificate. Note: Certificates are
installed using the Security settings.
• If required, tap User certificate and select a user certificate. Note: User certificates are installed using the
Location & security settings.
Wireless | 129
MN001456A01-A | February 2015 |
Send Feedback
To Next Page
Loading...
