Figure 30: Available/Busy Status Selection
2 Tap Available or Busy.
Status is immediately set to the selected state.
3.3.2.2 Moving Widgets
When and where to use: There is a need to move a widget to another location.
Procedure:
1 Navigate to the Home screen panel where the widget is located.
2 Touch and hold the widget; then, slide the widget to a new location.
If you want to move the widget to another panel, slide the widget left or right to that panel; then slide the widget to
a location in the panel.
3.3.2.3 Removing Widgets
When and where to use: There is a need to remove a widget from a Home screen panel.
Procedure:
1 Slide the Home screen panel until you locate the panel that holds the widget that you want to remove.
2 Touch and hold the widget while sliding it down to the bottom of the panel.
X Remove appears near the bottom of the screen.
3 Slide the widget to X Remove until the widget turns red; then, release the widget.
The widget is removed from the panel.
Note: The widget is only removed from the panel. It is not deleted from the LEX L10.
58 | Using the LEX L10
Send Feedback | February 2015 | MN001456A01-A
To Next Page
Loading...
