Motorola LEX L10 - Specifying a Pattern; Specifying a PIN or Password; Setting the Timeout for Locking the LEX L10

If None or Slide is selected, the Security screen is re-displayed. If Pattern, PIN, or Password is selected, a
pattern, pin or password must be specified. Then, the Security screen is re-displayed.
The LEX L10 is now set to lock.
Postrequisites: Specify a pattern as described in Specifying a Pattern
on page 41 Specify a pin, or password as
described in Specifying a PIN or Password on page 41. Then, specify a timeout value as described in Setting the
Timeout for Locking the LEX L10 on page 41.
2.9.1.1 Specifying a Pattern
Prerequisites: The Pattern option has been selected for Screen lock.
Procedure:
1
Tap
.
2
Tap .
3 Tap Security lock.
4 Select Pattern.
5 Using a finger, draw a pattern to unlock your LEX L10
6 Tap Continue.
7 Draw the same pattern again.
8 Tap Confirm.
The Security screen is re-displayed.
A pattern must be entered to unlock the LEX L10.
2.9.1.2 Specifying a PIN or Password
Prerequisites: The PIN or Password option has been selected for Screen lock.
Procedure:
1
Tap .
2
Tap .
3 Tap Security lock.
4 Select PIN or Password.
5 Enter a pin or password.
6 Tap Continue.
7 Enter the pin or password again.
8 Tap OK.
The Security screen is re-displayed.
A pin or password must be entered to unlock the LEX L10.
2.9.1.3 Setting the Timeout for Locking the LEX L10
Select a timeout value to lock the LEX L10.
Prerequisites: Screen lock must be set to Pattern, PIN, or Password.
Procedure:
1
Tap .
Getting Started with the LEX L10 | 41
MN001456A01-A | February 2015 | Send Feedback