Motorola LEX L10 - Setting Auto-Sync; Disabling Data When Roaming; Limiting Data Connection to a Network; Editing the Access Point Name

8.1.2.2 Setting Auto-Sync
You can also conserve data usage by syncing your apps manually, only when you need the data, rather than relying on
auto-sync.
When and where to use: Use this procedure to set Auto-Sync.
Procedure:
To turn auto-sync off or on, tap → Auto-sync data.
8.1.3 Disabling Data When Roaming
To prevent the LEX L10 from transmitting data over other carriers’ mobile networks when leaving an area that is
covered by the carrier’s networks. This is useful for controlling expenses if the service plan does not include data
roaming.
Procedure:
1
Tap .
2
Tap .
3 Tap More... .
4 Tap Mobile networks.
5 Un-check Data roaming.
6
Tap .
8.1.4 Limiting Data Connection to a Network
Note: This feature is only available on some networks. Check with service provider.
You can limit the device Private or Public services or extend the battery life by limiting the data connections to 2G
networks (GPRS or EDGE). For example, when connected to a 2G network, the user may want to postpone activities
that transmit a lot of data, such as sending, uploading, or downloading pictures or video, until they are connected to a
faster mobile or other wireless network.
Procedure:
1
Tap .
2
Tap .
3 Tap More ... .
4 Tap Mobile networks.
5 Tap Network Mode.
6 Tap 2G only or 3G only or 4G only or let the LEX L10 select automatically by touching 2G/3G/4G auto.
7
Tap
.
8.1.5 Editing the Access Point Name
Note: Many service provider Access Point Name (APN) data are pre-configured in the LEX L10.
Wireless | 125
MN001456A01-A | February 2015 | Send Feedback