Figure 100: Desktop Cradle
Charging the LEX L10
To charge the LEX L10, insert the LEX L10 units by placing the bottom of the LEX L10, at a slight forward angle,
into the cradle.
The LEX L10's LED shows the status of the battery charging. See Battery Charge LED Status for charging status
indications. The 2280 mAh battery charges in approximately ten hours.
Charge the LEX L10 units in temperatures from 0°C to +45°C (32°F to 113°F) ). Note that charging is intelligently
controlled by the LEX L10. To accomplish this, for small periods of time, the LEX L10 alternately enables and
disables battery charging to keep the battery at acceptable temperatures. The LEX L10 indicates when charging is
disabled due to abnormal temperatures via its notification LED.
9.4 Vehicle Cradle
Install the vehicle mount on the surface of the vehicle that is reasonably flat and free of dirt and oil. Clean the
mounting surface with a glass cleaner and a clean cotton cloth. Install the vehicle mount on the windshield or other
flat car surface.
Caution: Some states prohibit the mounting of any electronic device in any location on the vehicle
dashboard. Be sure to check with local laws acceptable mounting areas before installing the auto mounting
kit.
Accessories | 143
MN001456A01-A | February 2015 | Send Feedback
To Next Page
Loading...
