Moxa Technologies AWK Series User Manual

AWK Series User Manual
56
Configure the following settings
Operation Mode
NOTE
The AWK-1151C is a client device and does not support AP and Master mode.
Setting
Description
Factory Default
Disabled
Disable the operation mode.
Disabled
AP
Specify the operation mode as AP. Refer to AP Mode
Settings. (AWK-3252A, AWK-4252A only)
Master
Specify the operation mode as Master. Refer to Master Mode
Settings. (AWK-3252A, AWK-4252A only)
Sniffer
Specify the operation mode as Sniffer. Refer to Sniffer Mode
Settings.
Client
Specify the operation mode as Client. Refer to Client Mode
Settings.
Client-Router
Specify the operation mode as Client-Router. Refer to Client-
Router Mode Settings.
Slave
Specify the operation mode as Slave. Refer to Slave Mode
Settings.
AP Mode Settings
Select AP from the drop-down list of Operation Mode. AP Mode requires at least one active SSID.
NOTE
AP mode is only supported by the AWK-3252A and AWK-4252A Series.
Environment
Setting
Description
Factory Default
Indoor
Set the application environment to indoor. Available channels
vary depending on the selection.
Indoor
Outdoor
Set the application environment to outdoor. Available channels
vary depending on the selection.
For SSID and security settings, refer to Create a New SSID.
For configuring RF settings, refer to RF Settings.
When finished, click APPLY to change the operation mode.
Master Mode Settings
Select Master from the drop-down list of Operation Mode. Master Mode requires at least one active SSID.

Moxa Technologies AWK Series Specifications

General

Brand	Moxa Technologies
Model	AWK Series
Category	Network Hardware
Language	English