Moxa Technologies NPort 5100A Series - Network Settings

NPort 5100A Series Web Console Configuration
5-7
Telnet console
Setting Factory Default Necessity
Enable or Disable Enable Required
ATTENTION
If you disable both the “Web console” and “Telnet console,” you can still use NPort Administrator to configure
NPort 5100A device servers either locally or remotely over the network. Refer to Chapter 6 for more details.
Reset button protect
Setting Factory Default Necessity
No or Yes None Optional
NOTE: Select the Yes option to allow limited use of the Reset Button. In this case, the Reset Button can be
used for only 60 seconds. I.e., 60 seconds after booting up, the Reset Button will be disabled automatically.
Network Settings
You must assign a valid IP address to the NPort 5100A before it will work in your network environment. Your
network system administrator should provide you with an IP address and related settings for your network. The
IP address must be unique within the network (otherwise, the NPort 5100A will not have a valid connection to
the network). First time users can refer to Chapter 3, Initial IP Address Configuration, for more
information.
You can choose from four possible IP Configuration modes—Static, DHCP, DHCP/BOOTP, and BOOTP—
OTndBfigunder the web console screen’s IP configuration drop-down box.