Moxa Technologies NPort 5100A Series - Pair Connection Slave Mode; Ethernet Modem Mode

NPort 5100A Series Web Console Configuration
5-26
Pair Connection Slave Mode
When you select Pair Connection Slave Mode for the Operation mode of one of the NPort 5100A device
servers this NPort 5100A will be acting as a TCP server.
TCP alive check time
Setting Factory Default Necessity
0 to 99 min 7 min Required
0 min: TCP connection is not closed due to an idle TCP connection.
1 to 99 min: The NPort 5100A closes the TCP connection automatically if there is no TCP activity for the given
time.
Local TCP port
Setting Factory Default Necessity
TCP port No. (e.g.,
4001)
4001 Required
This Port No. must be the same port No. that you set up for the Pair Connection “Master” device server
Ethernet Modem Mode