NPort 5100A Series Web Console Configuration
SNMP Trap Server
SNMP trap server IP or domain name
Setting Factory Default Necessity
IP address or Domain
Name
None Optional
Event Type
Cold start
“Cold start” refers to starting the system from power off (contrast this with warm start). When performing a
cold start, the NPort 5100A will automatically issue an Auto warning message by e-mail, or send an SNMP trap
after booting up.
Warm start
“Warm start” refers to restarting the computer without turning the power off. When performing a warm start,
the NPort 5100A will automatically send an e-mail, or send an SNMP trap after rebooting.
Authentication failure
The user inputs a wrong password from the Console or Administrator. When authentication failure occurs, the
NPort will immediately send an e-mail or send an SNMP trap.
IP address changed
The user has changed the NPort 5100A’s IP address. When the IP address changes, the NPort 5100A will send
an e-mail with the new IP address before the NPort 5100A reboots. If the NPort 5100A is unable to send an
e-mail message to the mail server within 15 seconds, the NPort 5100A will reboot anyway, and abort the e-mail
auto warning.
Password changed
The user has changed the NPort 5100A’s password. When the password changes, the NPort 5100A will send an
e-mail with the password changed notice before the NPort 5100A reboots. If the NPort 5100A is unable to send
an e-mail message to the mail server within 15 seconds, the NPort 5100A will reboot anyway, and abort the
e-mail auto warning.
To Next Page
Loading...
