Moxa Technologies NPort 5100A Series - Opening Your Browser

NPort 5100A Series Web Console Configuration
5-2
Opening Your Browser
1. Open your browser with the cookie function enabled. (To enable your browser for cookies, right click on
your desktop Internet Explorer icon, select Properties, click on the Security tab, and then select the three
Enable options as shown in the figure below.)
2. Type 192.168.127.254 in the Address input box (use the correct IP address if different from the default),
and then press Enter.
3. Input the password if prompted. The password will be transmitted with MD5 encryption over the Ethernet.
Note that you will not be prompted to enter the password if the NPort 5100A is not currently password
protected.
ATTENTION
If you use other
web browsers, remember to Enable the functions to “allow cookies that are stored on your
computer
” or “allow per-session cookies.” NPort 5100A uses cookies only for “password” transmission.
ATTENTION
Refer to Chapter 3, Initial IP Address Configuration, to see how to configure the IP address. Examples shown
in this chapter use the Factory Default IP address (192.168.127.254).