Moxa Technologies NPort 5100A Series - Adding a Port to a COM Group

NPort 5100A Series Configuring NPort Administrator
6-23
3. You will be able to view the serial ports that were assigned to and removed from the Group. Click Apply to
apply the settings.
4. Finally, click Yes to confirm.
Adding a Port to a COM Group
Follow the steps below to add a serial port into an existing COM Group:
1. Select the serial port that you are adding and right-click to select COM Settings.
2. Select the COM number of the COM Group you are adding and check mark the Grouping selected port(s)
together check box and then click OK.